Name of the tunnel traffic policy to activate or bind.
This is mandatory parameter.

Integer specifying the policy's priority. The lower the number, the higher the priority. Policies are evaluated in the order of their priority numbers.
Maximum value = 2147483647.

Expression or other value specifying the next policy to evaluate if the current policy evaluates to TRUE. Specify one of the following values: * NEXT - Evaluate the policy with the next higher priority number. * END - End policy evaluation. * USE_INVOCATION_RESULT - Applicable if this policy invokes another policy label. If the final goto in the invoked policy label has a value of END, the evaluation stops. If the final goto is anything other than END, the current policy l abel performs a NEXT. * An expression that evaluates to a number. If you specify an expression, the number to which it evaluates determines the next policy to evaluate, as follows: * If the expression evaluates to a higher numbered priority, the policy with that priority is evaluated next. * If the expression evaluates to the priority of the current policy, the policy with the next higher numbered priority is evaluated next. * If the expression evaluates to a number that is larger than the largest numbered priority, policy evaluation ends. An UNDEF event is triggered if: * The expression is invalid. * The expression evaluates to a priority number that is smaller than the current policy's priority number. * The expression evaluates to a priority number that is between the current policy's priority number (say, 30) and the highest priority number (say, 100), but does not match any configured priority number (for example, the expression ev aluates to the number 85). This example assumes that the priority number increments by 10 for every successive policy, and therefore a priority number of 85 does not exist in the policy label.

Current state of the binding. If the binding is enabled, the policy is active.
Default value = ENABLED.
Possible Values : ENABLED, DISABLED.

Global bind point, specifying where to bind the policy. This is relevant for advanced (default-syntax) policies only.
Default value = NS_BINDPOINT_NONE.
Possible Values : REQ_OVERRIDE, REQ_DEFAULT, RES_OVERRIDE, RES_DEFAULT.