Smpp

all the commands associated with smpp.

Configuration APIs


Use this method to adds an SMPP user. The user name and password that you specify in this method are added to the configuration file and used to authenticate the user.


Use this method to get the SMPP parameters configured on the Citrix ADC.


Use this method to get the specified SMPP user or, if no user is specified, all the SMPP users configured on the appliance.


Use this method to removes an SMPP user from the Citrix ADC.


Use this method to set numbering Plan Indicator, such as landline, data, or WAP client, used in the ESME address sent in the bind request.


Use this method to set set of SME addresses, sent in the bind request, serviced by the ESME.


Use this method to set type of Number, such as an international number or a national number, used in the ESME address sent in the bind request.


Use this method to set mode in which the client binds to the ADC. Applicable settings function as follows:
* TRANSCEIVER - Client can send and receive messages to and from the message center.
* TRANSMITTERONLY - Client can only send messages.
* RECEIVERONLY - Client can only receive messages.


Use this method to set queue SMPP messages if a client that is capable of receiving the destination address messages is not available.


Use this method to set maximum number of SMPP messages that can be queued. After the limit is reached, the Citrix ADC sends a deliver_sm_resp PDU, with an appropriate error message, to the message center.


Use this method to set the SMPP users password.


Remove smpp param addrnpi setting.


Remove smpp param addrrange setting.


Remove smpp param addrton setting.


Remove smpp param clientmode setting.


Remove smpp param msgqueue setting.


Remove smpp param msgqueuesize setting.